Clutch Housing Overview

Clutch Housing Overview






1 Bushing for Selector Rods

• Pulling out, refer to => [ Pulling Out Bearing Bushing for Selector Rod ] Clutch Housing

• Driving in, refer to => [ Driving in Bushing for Selector Rod to Tool Stop ] Clutch Housing

2 Axle For Reverse Gear Shift Fork

• Cannot be removed with workshop equipment

• Pressing into clutch housing, refer to => [ Press Axle for Reverse Gear Shift Fork Into Clutch Housing ] Clutch Housing

3 Needle Bearing for Reverse Shaft

• Replace after each disassembly

• Pulling out, refer to => [ Pulling Needle Bearing Out of Clutch Housing ] Clutch Housing

• Installing, refer to => [ Needle Bearing , Pressing Into Clutch Housing ] Clutch Housing

4 Alignment Bushing

• Quantity: 2

5 Clutch Housing

• Adjust output shafts and differential, if replacing, refer to => [ Adjustment Overview ] Adjustment Overview

6 Input Shaft Seal

• Replace, refer to => [ Input Shaft Seal ] Input Shaft Seal

7 Stub Shaft Or Flange Shaft Sealing Ring

• Allocation, refer to the Parts Catalog

• Replace on stub shaft, refer to => [ Right Stub Shaft Seal, through Transmission Build Date 31 10 4, Replacing ] Right Stub Shaft Seal, Through Transmission Build Date 31 10 4, Replacing

• Replace on flange shaft, refer to => [ Right Flange Shaft Seal, from Transmission Build Date 01 11 4, Replacing ] Right Flange Shaft Seal, from Transmission Build Date 01 11 4, Replacing

8 Adjustment Shim

• For the differential

• Installation position: Shoulder on inner diameter faces toward seal - item 7 - => [ (Item 7) Stub Shaft Or Flange Shaft Sealing Ring ]

9 Outer Race For Tapered Roller Bearing

• For the differential

• Removing and installing, refer to => [ Differential Assembly Overview ] Description and Operation

• Adjust, if differential is replaced, refer to => [ Adjusting the Differential ] Adjusting the Differential

10 Oil Deflector Ring

• Installation position: Shoulder at hole points toward output shaft

11 Outer Race For Tapered Roller Bearing

• For output shaft for 1st to 4th gear

• Removing and installing, refer to => [ Output Shaft, 1st to 4th Gears ] Output Shaft, 1st to 4th Gears

• Adjust, if output shaft for 1st to 4th gear is replaced, refer to => [ Output Shaft, 1st to 4th Gears, Adjusting ] Output Shaft, 1st to 4th Gears, Adjusting

12 Outer Race For Tapered Roller Bearing

• For output shaft 5th/6th gear/reverse gear

• Removing and installing, refer to => [ Output Shaft, 5th, 6th and Reverse Gears ] Output Shaft, 5th, 6th and Reverse Gears

• Adjust, if output shaft for 5th/6th gear/reverse gear is replaced, refer to => [ Output Shaft, 5th, 6th and Reverse Gears, Adjusting ] Output Shaft, 5th, 6th and Reverse Gears, Adjusting

13 Adjustment Shim

• For output shaft 5th/6th gear/reverse gear

• 0.65 mm thick

14 Roller Bearing

• For input shaft

• Removing and installing, refer to => [ Input Shaft ] Input Shaft

15 Magnet

• Held in place by housing joint surface

16 Cap