Input Shaft Seal

Input Shaft Seal

Special tools, testers and auxiliary items required

• Extractor Lever (T20143/1)

• Thrust Piece (T40008)

• Sealing Grease (G 052 128 A1)

- Remove transmission. Refer to => [ Transmission, Removing ] Transmission, Removing.

- Remove the slave cylinder with release bearing => [ Clutch Slave Cylinder with Release Bearing ] Service and Repair.

- Pry out input shaft seal using (T20143/1).






• Do not damage the seal running surface on the input shaft.

- Fill space between sealing lip and dust lip - arrow - halfway with sealing grease (G 052 128 A1).






- Drive in seal using (T40008) until it is flush.






- Install the slave cylinder with release bearing. Refer to => [ Clutch Slave Cylinder with Release Bearing ] Service and Repair.

- Install transmission. Refer to => [ Transmission, Installing ] Transmission, Installing.