Right Flange Shaft Seal, from Transmission Build Date 01 11 4, Replacing

Right Flange Shaft Seal, from Transmission Build Date 01 11 4, Replacing

Special tools, testers and auxiliary items required

• Thrust Piece (3305)

• Extractor Lever (T20143/2)

• Oil receptacle

• Sealing grease (G 052 128 A1)

• Transmission installed.

- Remove the center noise insulation fasteners - 1 to 3 -.






- Remove right drive axle heat shield - arrows -.






- Remove right drive axle from transmission flanged shaft - A -.






- Secure the drive axles with bundling wire, making sure not to damage the protective surface coating.

- Remove bolt for flange shaft - arrow -, by screwing two bolts into the flange and counter-holding flange shaft using a pry bar.






- Place appropriate receptacle underneath transmission.

- Pull out flange shaft with spring.

- Pull out sealing ring for flange shaft using Extractor Lever (T20143/2).






Installing

- Lightly oil the outer circumference of the new seal.

- Fill area between sealing lip and dust lip - arrow - halfway with Sealing Grease (G 052 128 A1).






- Drive new seal in as far as the stop; be sure not to distort seal.






Secure and tighten the flange shaft and countersunk bolt - arrow -. Tightening specification => [ (Item 12) Countersunk Bolt - 33 Nm ] Description and Operation.






The rest of the installation follows the reverse order of removal, note the following:

- Fasten the right drive axle to the flange shaft - A - of the transmission.






- Install the right drive axle heat shield.

- Check gear oil level in manual transmission and fill. Refer to => [ Manual Transmission, Checking Gear Oil Level ] Service and Repair.

Tightening Specifications