Data List Reference Table & Normal Scan Data Values

DATA LIST REFERENCE TABLE

Part 1:

Part 2:

Part 3:

Part 4:

Part 5:

Part 6:

Part 7:

Part 8:

Part 9:

Part 10:

Part 11:

Part 12:

Part 13:

CAUTION:
- When shifting the select lever to D range, the brakes should be applied so that the vehicle does not move forward.
- Driving tests always need two persons: one driver and one observer.

NOTE: *1: If the idle speed is lower than the standard value on a very cold engine [approximately -20 degrees C (-4 degrees F)] even when the IAC motor is fully opened, the air volume limiter built in the throttle body could be defective.

NOTE: *2: In a new vehicle [driven approximately 500 km (311 mile) or less], the step of the stepper motor is sometimes 30 steps greater than the standard value.

NOTE: *3: The injector drive time represents the time when the cranking speed is at 250 r/min or below when the power supply voltage is 11 volts.

NOTE: *4: In a new vehicle [driven approximately 500 km (311 mile) or less], the injector drive time is sometimes 10% longer than the standard time.

NOTE: *5: In a new vehicle [driven approximately 500 km (311 mile) or less], the volume airflow sensor output frequency is sometimes 10% higher than the standard frequency.

NOTE: *6: GST items. [Data list items consist of M.U.T.-III items and GST items. GST items can be accessed through the use of a general scan tool (GST). When scan tool MB991958 (M.U.T.-III sub assembly) is used, M.U.T.-III items appear alphabetically; then, GST items appear alphabetically. The black and white characters of the GST items are inverted from the M.U.T.-III items.]