Auxiliary Component Bracket Ribbed Belt Drive Overview

Auxiliary Component Bracket Ribbed Belt Drive Overview






1 Ribbed Belt

• Check for wear

• Before removing, mark direction of rotation using chalk or felt-tip marker

• Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

• Do not kink

• When installing, make sure it is seated correctly on the ribbed belt pulleys

2 Bolt

• 20 Nm plus an additional 90° turn

• Replace

3 Vibration Damper

• With double ribbed belt pulley

• Removing and installing, refer to => [ Vibration Damper ] Service and Repair

4 Cover

• For the idler roller

5 Idler Roller

• 40 Nm

• For the ribbed belt

6 Bolt

7 Generator

8 Bolt

• 20 Nm

9 Bracket

• For generator

10 Bolt

• Tightening specification => [ (Item 2) Bolt ] Coolant Pump and Thermostat Overview

11 Ribbed Belt Pulley

• For coolant pump

• Removing and installing, refer to => [ Coolant Pump ] Coolant Pump

12 Bolt

• Tightening specification => [ (Item 1) Bolt ] Coolant Pump and Thermostat Overview

13 Coolant Pump

• Removing and installing, refer to => [ Coolant Pump ] Coolant Pump

14 Bolt

15 Bolt

16 Bracket

• For power steering pump

17 Slide Bushing

18 Bolt

19 Bolt

20 Power Steering Pump

21 Ribbed Belt Pulley

• For power steering pump

• Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

22 Bolt

23 Tensioning Element

• 40 Nm

• For the ribbed belt

• Removing and installing, refer to => [ Ribbed Belt Tensioner ] Ribbed Belt Tensioner

24 Bracket

• For air conditioning compressor

25 Bolt

26 A/C Compressor

• Do not unfasten/separate refrigerant lines

27 Bolt

28 Alignment Bushing

• Quantity: 2

29 Cover

• For tensioning element

30 Sealing Flange (belt pulley side)

• Removing and installing, refer to => [ Sealing Flange with Crankshaft Seal, Belt Pulley Side ] Service and Repair

Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence





- Tighten the bolts - arrows - in a diagonal sequence in stages to 9 Nm.