Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• Locking Pin (T10060 A)

Removing






- Remove the supercharger ribbed belt. Refer to => [ Supercharger Ribbed Belt ] Supercharger Ribbed Belt.

- Remove the bolt - arrow - and remove the idler roller.








Risk of destroying due to reversed running direction on a used ribbed belt.

• Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

- To release the tension on the ribbed belt, swivel the tensioner clockwise - arrow - and then lock the tensioner using (T10060 A).

- Remove ribbed belt.

Installing






Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Supercharger Ribbed Belt Drive Overview ] Supercharger Ribbed Belt Drive Overview.

- Place the ribbed belt over the pulley as illustrated.

1. Generator

2. Idler roller

3. Coolant pump

4. Power steering pump

5. Air Conditioning (A/C) Compressor

6. Ribbed belt tensioning damper

7. Vibration damper


• When installing the ribbed belt, make sure it is seated correctly on the pulleys.

- Start the engine and check the belt routing.

- Install the supercharger ribbed belt. Refer to => [ Supercharger Ribbed Belt ] Supercharger Ribbed Belt.