Supercharger Ribbed Belt

Supercharger Ribbed Belt

Special tools, testers and auxiliary items required

• Locking Pin (T10060 A)

Removing






Risk of injury through fan turning on automatically.

• The radiator fan can come on even when the ignition is turned off, for example, caused by the heat still in the engine compartment.

- Remove the front engine cover - 1 - upward.








Risk of destroying due to reversed running direction on a used ribbed belt.

• Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

- Pivot the tensioner clockwise - arrow - to release the tension on the ribbed belt.

- Remove the ribbed belt and secure the tensioning element with (T10060 A).

Installing






Install in reverse order, paying attention to the following:

- Place the ribbed belt over the pulley as illustrated:

1. Tensioning element

2. Compressor

3. Idler roller

4. Vibration damper


• When installing the ribbed belt, make sure it is seated correctly on the pulleys.

- Start the engine and check the belt routing.