Backrest Assembly Overview

Backrest Assembly Overview






1 Seat pan

2 Bolt

• Quantity: 4

• self-locking

• Replacing

• Threaded holes for screws must be cleaned, for example, with thread cutter

• 34.5 Nm

3 Trim

• for backrest hinge trim on tunnel side

• Removing and Installing, refer to => [ Backrest Hinge Trim ] Backrest Hinge Trim

4 Backrest

• Removing and Installing, refer to => [ Backrest ] Backrest

5 Headrest

• Removing and Installing, refer to => [ Headrest ] Headrest

6 Clips

• with hooks

• Quantity: 2

• Replacing

• Insert into the backrest cover

• Remove clips left in the mounting points of the rear lid and use for installation in the trim

• Replace damaged or deformed clips

7 Backrest cover

• Removing and Installing, refer to => [ Backrest Cover ] Backrest Cover

8 Rubber strap

• with hooks

• Quantity: 2

9 Trim

• for sill side backrest hinge

• Removing and Installing, refer to => [ Backrest Hinge Trim ] Backrest Hinge Trim

10 Expanding rivet

11 Electrical wiring harness

• from the side airbag to the connector station

• Depending on the vehicle version, there may be more wiring harnesses, such as for the backrest heating

12 Bolt

• 10 Nm

13 Belt guide

• Removing and Installing, refer to => [ Seat Belt Guide ] Seat Belt Guide