Backrest Cover

Backrest Cover

Special tools, testers and auxiliary items required

• Pry lever (80 - 200)

Removing






- Move the front seat all the way forward/up.

• The clips - 1 - and - 2 - together with hooks on the backrest frame can only be detached up to the first catch.

- Release the clips - 1 - and - 2 - up to the first retainer - A arrows - using a pry lever (80 - 200).

- To disengage the clips - 1 - with the hooks, move the backrest cover - 3 - in - direction of arrow C -. The clips will slide out of the guide on the backrest cover.

- Then, to disengage the clips - 2 - with the hooks, move the backrest cover in - direction of arrow B -. The clips will slide out of the guide on the backrest cover.

- Pull the backrest cover - 1 - in the upper section as far as possible toward the rear from the backrest- arrow -.






- Press down and remove the backrest cover hooks - 2 - with a large flat blade screwdriver from the backrest frame.

• Use a flashlight and mirror if necessary.

- Detach left and right rubber strap - 1 - at the bottom of the seat pan.






- Pull off backrest cover in upward direction.

Installation

Install in reverse order of removal. Note the following:

- Install backrest cover with catches at the bottom of the backrest frame.

- Insert the clips together with hooks into the guides on the backrest cover.

- Forcefully press backrest cover in the direction of the backrest until the clips engage audibly.

- Check if the backrest cover is correctly latched.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Backrest Assembly Overview ] Backrest Assembly Overview.