Clutch Pedal Assembly Overview

Clutch Pedal Assembly Overview





1 Bulkhead

• With mount for mounting bracket

2 Gasket

• Always replace

• Between mounting bracket and bulkhead

• Self-adhesive

• Adhere to mounting bracket

3 Mounting bracket

• For mounting clutch pedal

• Removing and installing --> [ Mounting Bracket ] Mounting Bracket.

4 Bolt

5 Over-center spring

• Removing and installing --> [ Over-Center Spring ] Over-Center Spring.

6 Bushing

7 Pivot pin

8 Clutch pedal

• Removing and installing --> [ Clutch Pedal ] Clutch Pedal.

9 Base block

• To remove and install, disconnect master cylinder from clutch pedal --> [ Clutch Pedal ] Clutch Pedal.

10 Gasket

• Always replace

• Between master cylinder and mounting bracket

11 Master cylinder

• Removing and installing after removing mounting bracket --> [ Master Cylinder ] Service and Repair

12 Clutch position sensor (G476)

• Removing and installing --> [ Clutch Position Sensor ] Service and Repair.

• Can be tested in "Guided Fault Finding" using vehicle diagnosis, testing and information system (VAS 5051)

13 Clip

• To remove and install the hose/line assembly, pull the clip out to the stop

14 Supply hose

15 Self-locking hex nut, 25 Nm

• Quantity: 3

• For mounting bracket to bulkhead

• Always replace

16 Hex nut, tighten to 25 Nm.

• Always replace

17 End stop

• For clutch pedal