Luggage Side Lower Finisher

LUGGAGE FLOOR TRIM

LUGGAGE SIDE LOWER FINISHER : Removal and Installation


CAUTION:
Never damage the body.

REMOVAL

1.Remove rear body side welt. Refer to "BODY SIDE WELT : Removal and Installation" Body Side Welt.
2.Remove luggage rear plate. Refer to "LUGGAGE REAR PLATE : Removal and Installation" Luggage Rear Plate.
3.Remove luggage floor front finisher. Refer to "LUGGAGE FLOOR FRONT FINISHER : Removal and Installation" Luggage Floor Front Finisher.
4.Remove luggage net hook.





Disengage net hook pin fixing pawl with a remover tool (A), and then remove luggage net hook.

5.Remove luggage room lamp. Refer to "Removal and Installation" Removal And Installation.
6.Remove luggage side lower finisher.
a.Remove hook that is hooked to body panel.










b.Disengage luggage side lower finisher fixing clips and pawls with a remover tool (A), and then remove luggage side lower finisher.


INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:
When installing, check in advance that clips and pawls are accurately aligned with the holes on body side, and then install by pressing in.

Removal and installation of shock absorber mask


CAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
EMOVAL
1.Apply protective tape (A) on the parts to protect it from damage.










2.Disengage shock absorber mask fixing pawls with a remover tool (A), and then remove shock absorber mask.

INSTALLATION
Install in the reverse order of removal.