Headliner: Service and Repair

HEADLINING


Removal and Installation

With Sunroof






Without Sunroof






REMOVAL
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
2. Recline front seatback to full down position.
3. Remove front seat belt shoulder anchor RH/LH. Refer to Front Seat Belt.
4. Remove center console. Refer to Removal And Installation.
5. Remove front pillar finisher RH/LH. Refer to Body Side Trim.
6. Remove both center pillar upper and lower RH/LH finisher. Refer to Body Side Trim.
7. Remove rear pillar finisher. Refer to Body Side Trim.
8. Disconnect room lamp harness.
9. Remove front and rear body side welt RH/LH. Refer to Body Side Trim.
10. Remove the screw, them remove assist grips.
11. Disconnect the connector and remove the sunvisor screws, then remove sunvisor RH/LH.
12. Remove the sunvisor holder screws, then remove sunvisor holder RH/LH.
13. Remove the CD holder, then remove the screws and CD holder escutcheon (if equipped).
14. Remove sunroof opening welt (if equipped).
15. Remove lens and one screw, then disconnect the connector and remove the roof map lamp assembly.
16. Remove lens and two screws, then disconnect the connector and remove interior room lamp.
17. Remove three headlining clips.





18. Position the headlining so the front edge goes partially through the opening of the right side front door.
19. Position the headlining so the rear edge goes through the opening of the left rear door, then remove headlining through the rear door opening.

CAUTION:
- Two technicians should be used to avoid damage when removing or replacing headlining.
- During headlining removal and installation, cover the center console finisher upper surface to prevent damage.
- Do not bend headlining when removing.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Avoid headlining damage when installing by inserting rear clips first during assembly.