Front Seat Belt

SEAT BELTS


Removal and Installation of Front Seat Belt







CAUTION:
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.

REMOVAL OF SEAT BELT RETRACTOR
1. Disconnect both the negative and positive battery terminals, then wait at least three minutes.
2. Remove the seat belt adjuster cover and shoulder anchor bolt.
3. Disconnect the belt tension sensor, then remove outer anchor cover and outer anchor bolt.
4. Remove the center pillar lower garnish. Refer to Body Side Trim.
5. Position the floor trim away from center pillar.





6. Disconnect seat belt pre-tensioner connector. Refer to Direct-Connect SRS Component Connectors.
7. Remove the retractor anchor bolt, then remove the seat belt retractor.

INSTALLATION OF SEAT BELT RETRACTOR
Installation is in the reverse order of removal.

REMOVAL OF SEAT BELT BUCKLE
1. Remove the floor center console assembly. Refer to Removal And Installation.
2. Remove the seat side cover. Refer to Disassembly and Assembly.





3. Disconnect the seat belt buckle harness connector (1).
Arrow Indicates Vehicle front
4. Remove the buckle anchor bolt (A), then remove the seat belt buckle (2).

INSTALLATION OF SEAT BELT BUCKLE
Installation is in the reverse order of removal.