Removal

SUSPENSION CONTROL: CONTROL VALVE ASSEMBLY (for Front Side): REMOVAL

CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing Suspension Control System.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System (for HDD):

After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE ROOM SIDE COVER RH Removal

5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

6. REMOVE COOL AIR INTAKE DUCT SEAL Removal

7. REMOVE RADIATOR GRILLE ASSEMBLY Removal

8. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH

9. REMOVE FRONT FENDER WHEEL OPENING MOULDING RH Removal

10. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Removal

11. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Removal

12. REMOVE FRONT FENDER LINER LH Removal

13. REMOVE FRONT FENDER LINER RH Removal

14. REMOVE FRONT BUMPER COVER Removal

15. REMOVE NO. 1 HEIGHT CONTROL VALVE SUB-ASSEMBLY

(a) Disconnect the connector.

(b) Disconnect the underside air tube Suspension Control System.

(d) Remove the 2 nuts and height control valve.