Removal

1UR-FSE ENGINE CONTROL SYSTEM: THROTTLE BODY: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE V-BANK COVER SUB-ASSEMBLY

(a) Using both hands, lift the rear side of the cover upwards to detach the 4 clips labeled B. Then slide the cover toward the front of the vehicle to detach the 2 clips labeled A and remove the V-bank cover.





NOTICE:
* The V-bank cover may be damaged if its front and rear are lifted at the same time.
* When detaching the clips labeled A, be sure to slide the cover toward the front of the vehicle.

4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY

(a) Remove the 5 clips A.





(b) Lift up the air cleaner inlet cover to detach the 4 clips B, and remove the air cleaner inlet cover.

5. REMOVE NO. 1 AIR CLEANER INLET

(a) Remove the 2 bolts.





(b) Hold the air cleaner inlet by the protrusions A and B, and detach the connections.





(c) Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion C.

(d) Hold the air cleaner inlet by the protrusions D and E, and detach the connections.

(e) Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion F.

6. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair

7. DRAIN ENGINE COOLANT Service and Repair

8. REMOVE INTAKE AIR CONNECTOR PIPE

(a) Disconnect the No. 1 and No. 2 ventilation hoses from the intake air connector pipe.





(b) for AWD:

Using a clip remover, detach the wire harness clamp.

(c) Loosen the 3 hose clamps, and remove the intake air connector pipe.

9. REMOVE THROTTLE BODY ASSEMBLY

(a) Disconnect the throttle motor connector.





(b) Remove the 4 bolts and throttle body.

(c) Disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body.





(d) Remove the gasket from the intake manifold.