Removal

PRE-COLLISION: DRIVER MONITOR ECU: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

5. REMOVE INSTRUMENT SIDE PANEL LH Removal

6. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING Removal

7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal

10. REMOVE DRIVER MONITOR ECU





(a) Disconnect the connectors.

(b) Remove the 2 nuts and ECU.