Removal

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH Removal

2. REMOVE ENGINE ROOM SIDE COVER RH Removal

3. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

4. REMOVE COOL AIR INTAKE DUCT SEAL Removal

5. REMOVE RADIATOR GRILLE Removal

6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

7. REMOVE HOOD LOCK CONTROL CABLE COVER

(a) Remove the 3 screws.





(b) Detach the claw and remove the cable cover.

8. REMOVE FRONT FENDER PROTECTOR UPPER LH

(a) Using a screwdriver, detach the 3 clips and remove the protector.





HINT
Tape the screwdriver tip before use.

9. REMOVE HOOD LOCK ASSEMBLY

(a) Remove the cap.





(b) Remove the 2 bolts and nut.

(c) Remove the hood lock.

(d) Disconnect the hood lock control cable.

10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Detach the 2 claws.





(b) Disconnect the hood lock control cable and remove the hood lock lever.

11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY





(a) Using a screwdriver, disconnect the clamps shown in the illustration.

HINT
Tape the screwdriver tip before use.

(b) Pull the cable from the engine room and remove it.