Removal
1UR-FSE EXHAUST: EXHAUST MANIFOLD: REMOVAL
1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag from working.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization
3. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
4. REMOVE COOL AIR INTAKE DUCT SEAL Removal
5. REMOVE ENGINE ROOM SIDE COVER LH Removal
6. REMOVE ENGINE ROOM SIDE COVER RH Removal
7. REMOVE ENGINE UNDER COVER
8. REMOVE NO. 2 ENGINE UNDER COVER
9. REMOVE REAR ENGINE UNDER COVER LH
10. REMOVE REAR ENGINE UNDER COVER RH
11. REMOVE NO. 1 AIR CLEANER INLET Removal
12. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal
13. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal
14. REMOVE V-RIBBED BELT Removal
15. REMOVE FRONT STABILIZER BAR (w/o Active Stabilizer System)
Removal
16. REMOVE FRONT ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY (w/ Active Stabilizer System)
Removal
17. REMOVE FRONT FLOOR COVER CENTER LH
(a) Remove the 3 nuts, 2 clips and floor cover.
18. REMOVE FRONT FLOOR COVER CENTER RH
(a) Remove the 3 nuts, 2 clips and floor cover.
19. REMOVE REAR NO. 1 FLOOR PANEL BRACE Removal
20. REMOVE FRONT CENTER FLOOR BRACE Removal
21. DISCONNECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) Removal
22. DISCONNECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) Removal
23. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Remove the 6 bolts, 4 nuts, 2 compression springs and front exhaust pipe assembly.
(b) Remove the 2 gaskets from the exhaust manifold.
24. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY Removal
25. REMOVE GENERATOR (for RH Side)
Removal
26. REMOVE OIL LEVEL DIPSTICK GUIDE SUB-ASSEMBLY (for RH Side) Removal
27. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR (for RH Side)
(a) Disconnect the air fuel ratio sensor connector.
(b) Remove the 3 bolts and No. 1 exhaust manifold heat insulator.
28. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH (for RH Side)
(a) Remove the 8 nuts and exhaust manifold RH.
(b) Remove the gasket.
29. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) Removal
30. DISCONNECT COMPRESSOR AND PULLEY (for LH Side) Removal
31. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (for LH Side)
(a) Disconnect the air fuel ratio sensor connector.
(b) Remove the bolt and wire harness bracket.
(c) Remove the 3 bolts and No. 2 exhaust manifold heat insulator.
32. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (for LH Side)
(a) Remove the 8 nuts and exhaust manifold LH.
(b) Remove the gasket.
33. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) Removal