Removal

1UR-FSE CHARGING: GENERATOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE ENGINE ROOM SIDE COVER RH Removal

6. REMOVE FRONT WHEELS

7. REMOVE ENGINE UNDER COVER

8. REMOVE REAR ENGINE UNDER COVER LH

9. REMOVE REAR ENGINE UNDER COVER RH

10. REMOVE NO. 1 AIR CLEANER INLET Removal

11. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

12. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

13. REMOVE V-RIBBED BELT Removal

14. DISCONNECT WIRE HARNESS

(a) Remove the clamp and the nut.





15. REMOVE FRONT STABILIZER BAR (w/o Active Stabilizer System)

(a) Remove the front stabilizer bar Removal.

16. REMOVE FRONT ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY (w/ Active Stabilizer System)

(a) Remove the front active stabilizer control actuator assembly Removal.

17. REMOVE GENERATOR

(a) Remove nut A, and disconnect the harness from the +B terminal.





(b) Remove bolt B, and disconnect the oil cooler tube.

(c) Remove clamp C.

(d) Disconnect generator connector D.

(e) Remove the nut and wire harness bracket.





(f) Remove the 2 bolts and 2 nuts.





(g) Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator.