Removal

INTERIOR: REAR SUNSHADE ASSEMBLY: REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
(a) Remove the rear seat Removal.
4. REMOVE REAR SEAT ASSEMBLY (for Power Seat)
(a) Remove the rear seat Removal.
5. REMOVE REAR SEAT ASSEMBLY (for Ottoman)
(a) Remove the rear seat Removal.
6. REMOVE REAR DOOR SCUFF PLATE LH
(a) for Standard Body:
Remove the rear door scuff plate Removal.
(b) for Long Body:
Remove the rear door scuff plate Removal.
7. REMOVE REAR DOOR SCUFF PLATE RH
(a) for Standard Body:
Remove the rear door scuff plate Removal.
(b) for Long Body:
Remove the rear door scuff plate Removal.
8. REMOVE REAR SEAT SIDE GARNISH LH Removal
9. REMOVE REAR SEAT SIDE GARNISH RH Removal
10. REMOVE ROOF SIDE GARNISH INNER LH Removal
11. REMOVE ROOF SIDE GARNISH INNER RH Removal
12. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY





(a) except Ottoman Seat:
Using a moulding remover, detach the 4 claws and remove the 3 belt guides.
(b) for Ottoman Seat:
Using a moulding remover, detach the 4 claws and remove the 2 belt guides.





(c) Detach the 2 clips of the panel. Then pass the rear seat belt floor anchors through the panel.
(d) W/O Rear Cooler:
Remove the panel.
(e) W/ Rear Cooler:
Disconnect the solar sensor connector and remove the panel.
13. REMOVE ROOF SIDE NO. 2 AIR DUCT LH (W/ Rear Cooler) Removal
14. REMOVE ROOF SIDE NO. 2 AIR DUCT RH (W/ Rear Cooler) Removal
15. REMOVE REAR NO. 4 AIR DUCT (W/ Rear Cooler) Removal
16. REMOVE REAR NO. 5 AIR DUCT (W/ Rear Cooler) Removal
17. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY Removal
18. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY





(a) Detach the 5 claws and 3 clips.
19. REMOVE REAR SUNSHADE ASSEMBLY





(a) Remove the 5 bolts.
(b) Loosen the bolt labeled A and remove the sunshade.
NOTE:
Do not remove the bolt labeled A.