Removal

1UR-FSE ENGINE MECHANICAL: FRONT ENGINE MOUNTING: REMOVAL

REMOVAL

1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCHARGE FUEL SYSTEM PRESSURE Removal

3. REMOVE COWL TOP VENTILATOR LOUVER Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

5. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

6. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

7. REMOVE ENGINE ROOM SIDE COVER RH Removal

8. REMOVE ENGINE ROOM SIDE COVER LH Removal

9. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair

10. REMOVE NO. 2 ENGINE UNDER COVER Removal

11. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER Removal

12. DRAIN ENGINE COOLANT Service and Repair

13. DISCONNECT NO. 1 OIL COOLER INLET HOSE Removal

14. DISCONNECT NO. 1 OIL COOLER OUTLET HOSE Removal

15. REMOVE FRONT WHEEL
16. REMOVE FRONT BUMPER COVER
(a) Remove the front bumper cover Removal.
17. REMOVE FRONT SUSPENSION CROSSMEMBER LOWER Removal

18. REMOVE NO. 1 AIR CLEANER INLET Removal

19. REMOVE INTAKE AIR CONNECTOR PIPE Removal

20. REMOVE V-RIBBED BELT Removal

21. REMOVE AIR CLEANER ASSEMBLY LH Removal

22. REMOVE AIR CLEANER ASSEMBLY RH Removal

23. DISCONNECT NO. 1 RADIATOR HOSE
24. DISCONNECT NO. 2 RADIATOR HOSE
25. REMOVE ENGINE ROOM ECU OUTLET DUCT Removal

26. DISCONNECT NO. 3 FUEL HOSE Removal

27. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY Removal

28. DISCONNECT HOSES AND CONNECTORS Removal

29. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Remove the front exhaust pipe Removal.
30. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Removal

31. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(a) Remove the propeller shaft Removal.
32. REMOVE FRONT STABILIZER BAR
(a) Remove the front stabilizer bar Removal.
33. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH Removal

34. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH Removal

35. REMOVE STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY (w/ VGRS) Removal

36. REMOVE STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY (w/o VGRS) Removal

37. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (w/ VGRS) Removal

38. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (w/o VGRS) Removal

39. REMOVE POWER STEERING LINK ASSEMBLY (w/ VGRS) Removal

40. REMOVE POWER STEERING LINK ASSEMBLY (w/o VGRS) Removal

41. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Removal

42. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY (for Bank 1) Removal

43. DISCONNECT COOLER COMPRESSOR ASSEMBLY Removal

44. DISCONNECT FRONT NO. 2 LOWER SUSPENSION ARM SUB-ASSEMBLY
(a) Disconnect the front No. 2 lower suspension arm Removal.
45. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

46. REMOVE ENGINE AND TRANSMISSION Removal

47. REMOVE OIL LEVEL DIPSTICK GUIDE Removal

48. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Removal

49. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY (for Bank 2) Removal

50. REMOVE OIL COOLER TUBE Removal

51. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR Removal

52. REMOVE STARTER ASSEMBLY Removal

53. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY Removal

54. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY Removal

55. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Removal

56. INSTALL ENGINE ON ENGINE STAND Removal

57. REMOVE ENGINE MOUNTING SPACER






(a) Remove the 2 mounting spacers.
58. REMOVE FRONT ENGINE MOUNTING INSULATOR






(a) Remove the 2 nuts and 2 engine mounting insulators.