Removal

1UR-FSE EXHAUST: EXHAUST PIPE: REMOVAL

REMOVAL
CAUTION:
- The procedures should be performed by at least 2 people.
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR Removal

4. REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR Removal

5. REMOVE NO. 6 ROCKER PANEL MOULDING PROTECTOR
(a) Remove the 2 clips, screw and protector.
6. REMOVE NO. 5 ROCKER PANEL MOULDING PROTECTOR
(a) Remove the 2 clips, screw and protector.
7. REMOVE REAR FLOOR SIDE MEMBER COVER LH






(a) Remove the clip, nut, 5 screws and cover.
8. REMOVE REAR FLOOR SIDE MEMBER COVER RH
(a) Remove the clip, nut, 5 screws and cover.
9. REMOVE FRONT FLOOR COVER LH






(a) Remove the 3 clips, 3 screws, 4 grommets and cover.
10. REMOVE FRONT FLOOR COVER RH
(a) Remove the 3 clips, 3 screws, 4 grommets and cover.
11. REMOVE FRONT FLOOR CENTER BRACE






(a) Remove the 4 bolts and brace.
12. DISCONNECT HEATED OXYGEN SENSOR (for Sensor 2)
(a) Disconnect the 2 grommets from the floor panel.
(b) Using SST, loosen the 2 sensors, and then disconnect the sensor by hand.
SST: 09224-00010
NOTE: Do not strike the metal part of the sensor.





13. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Temporarily loosen the 8 bolts on the tailpipe and manifold sides.
(b) Remove the 4 nuts and 4 bolts from the exhaust manifold LH and RH side.
(c) Remove the 4 bolts from the tailpipe LH and RH side. Then remove the front exhaust pipe.
(d) Remove the 2 gaskets from the exhaust manifold side and the 2 gaskets from the tailpipe side.
14. REMOVE TAILPIPE LH
(a) Disconnect the 3 exhaust pipe supports to remove the tailpipe.
15. REMOVE TAILPIPE RH
(a) Disconnect the 3 exhaust pipe supports to remove the tailpipe.





16. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY






(a) Remove the 2 bolts and bracket.