Removal And Installation

REAR PARCEL SHELF FINISHER

Removal and Installation


REMOVAL

1.Remove rear seatback and rear seat cushion. Removal and Installation.
2.Remove rear seat belt floor anchor bolts. Removal And Installation.
3.Remove rear kicking plate inner (LH and RH). Kicking Plate Inner.
4.Remove rear wheelhouse garnish (LH and RH). Rear Wheel House Garnish.
5.Remove rear pillar finisher (LH and RH). Rear Pillar Finisher.





6.Disengage child anchor cover (LH and RH) fixing pawls with a remover tool and then remove child anchor cover (LH and RH).










7.Hold rear parcel shelf finisher (1) from both sides, pull it upward to disengage the clips, and then disconnect high-mounted stop lamp harness connector (A) located on the left side only.
8.Remove rear parcel shelf finisher from vehicle body.
- With sunshade: Disengage clips on the back side and dual lock fastener (models with sunshade only), and then pull out toward vehicle front.
- Without sunshade: Disengage clips on the back side, and then pull out toward vehicle front.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Check that clips are securely fitted in panel holes on body when installing, and then press them in.
- Check the following after installation.
- From inside passenger room, check that black print on rear window glass is visible.
- From outside passenger room, check that there is a clearance between rear window glass and high mounted stop lamp cover of approximately 5.0 mm (0.197 in).
- From rear sunshade opening, check for engagement of pawls (models with sunshade).