Rear Wheel House Garnish

BODY SIDE TRIM

REAR WHEEL HOUSE GARNISH : Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL

1.Remove rear seat cushion and rear seatback. Removal and Installation.
2.Remove rear seat belt retractor anchor bolt (LH and RH). Removal And Installation.
3.Remove rear kicking plate inner. Kicking Plate Inner.





4.Remove clip (A).
5.Insert a remover tool between rear wheel house garnish and body panel to disengage the pawls as shown in the figure.
NOTE:
Remove according to the steps indicated in the figure to avoid damaging the fixing pawls.





6.Remove rear wheel house garnish from the body panel.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
Check that pawls are securely fitted in panel holes on body when installing, and then press pawls in.