Removal And Installation

FRONT SEAT BELT


SEAT BELT RETRACTOR : Removal and Installation


REMOVAL

CAUTION:
Before servicing SRS, turn the ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.

REMOVAL
1. Remove the outer anchor.
1. Slide the seat to the foremost position.
2. Remove the outer anchor cover.
3. Remove the mounting anchor bolt of the outer anchor.
2. Remove the shoulder anchor.
1. Remove the front kicking plate inner and rear kicking plate inner. Kicking Plate Inner, "KICKING PLATE
INNER : Removal and Installation"
2. Remove the center pillar lower garnish. Center Pillar Lower Garnish.
3. Remove the center pillar upper garnish. Center Pillar Upper Garnish.
4. Remove the mounting anchor nut of the shoulder anchor.
3. Remove seat belt pretensioner retractor.
1. Disconnect the pre-crash seat belt connector.
2. Disconnect the seat belt pretensioner connector.

CAUTION:





- For installing/removing seat belt pretensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
3. Remove the mounting bolt and mounting anchor bolt of the seat belt pretensioner retractor.
4. Remove the seat belt adjuster.
Remove the mounting anchor bolts of the seat belt adjuster.

INSTALLATION
Install in the reverse order of removal.