Center Pillar Lower Garnish

BODY SIDE TRIM


CENTER PILLAR LOWER GARNISH : Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL
1. Remove front kicking plate inner and rear kicking plate inner. Kicking Plate Inner.





2. Insert a remover tool between body panel and center pillar lower garnish to disengage the fixing clips and pawls as shown in the figure.

Circle: Clip
Triangle: Pawl

3. Pull back center pillar lower garnish to remove.

INSTALLATION
Note the following item, and then install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press clips in.