Transmission Shift Lever and Relay Lever Overview

Transmission Shift Lever and Relay Lever Overview

• Grease bearing areas and slide surfaces with grease (G 000 450 02).






1 Selector Mechanism Cover

• Removing and installing, refer to => [ Input Shaft, Output Shaft, Differential and Shift Rods Overview ] Input Shaft, Output Shaft, Differential and Shift Rods Overview

2 Selector Shaft

• Removing and installing, refer to => [ Input Shaft, Output Shaft, Differential and Shift Rods Overview ] Input Shaft, Output Shaft, Differential and Shift Rods Overview

3 Bushing

• discontinued from 05.2007 on the plastic relay lever

4 Retaining Washer

• discontinued from 05.2007 on the plastic relay lever

5 Oil Seal

• Replace, refer to => [ Selector Shaft Seal ] Selector Shaft Seal

6 Retaining Washer

7 Shift Cable

8 Nut

• 23 Nm

• Self-locking

• Replace

9 Transmission Shift Lever

• Only possible to install in one position

• starting in 06.2006 smaller bolt diameter for the cable retainer, refer to => [ Starting in 02.2006, Smaller Bolt Diameter for the Shift Cable Retainer ] 02Q Transmission

10 Retaining Washer

• Discontinued from 05.2007 on the plastic relay lever

11 Selector Cable

12 Selector Relay Lever

• Can be made of plastic or metal

• Plastic relay lever from 05.2007, refer to => [ Plastic Relay Lever ] 02Q Manual Transmission

13 Slide Shoe

14 Bushing

15 Lock Elbow

• For adjustment of shift mechanism, refer to => [ Shift Mechanism, Adjusting ] Adjustments

Installing the Transmission Shift Lever





- When positioning the transmission shift lever, make sure the gap - arrow A - is placed over the missing selector shaft teeth - arrow B -.

Installation Position, Transmission Shift Lever/Relay Lever





1 Transmission shift lever
2 The relay lever engages into the guide rail of the transmission selector lever, via the guide shoe - arrow -.

Removing the Relay Lever Clip





- Lift on the circlip - arrow -.