Balance Shaft Module, Removing

Balance Shaft Module, Removing

Special tools, testers and auxiliary items required

• Crankshaft Stop (T10050)

Procedure

- Remove vibration damper. Refer to => [ Vibration Damper ] Service and Repair.


Components could be destroyed by the toothed belt jump off.

• Only rotate the crankshaft in the direction of engine rotation.

- Turn the crankshaft by the toothed belt crankshaft sprocket bolt until the camshaft is at TDC.

- Secure the crankshaft with the (T10050).





• The markings on the toothed belt gear - 2 - and on the crankshaft stop - 1 - must align - arrow -. The tab of the crankshaft stop must engage in the bore of the sealing flange.

• The crankshaft stop can be pushed onto the toothed belt gear only from the front side of the splines.

- Remove the oil pan. Refer to => [ Oil Pan ] Service and Repair.

- Loosen the bolts in sequence - 8 to 1 -.





- Remove the bolts and remove the balance shaft assembly and oil pump.

• Installing a new balance shaft assembly, refer to => [ New Balance Shaft Assembly, Installing ] New Balance Shaft Assembly, Installing.

• Installing a used balance shaft assembly, refer to => [ Used Balance Shaft Module, Installing ] Used Balance Shaft Module, Installing.