Rear Frame

Rear Frame






1 Front Motor Support

• Removing and Installing, refer to => [ Front Glass Panel Slotted Guide Rail and Cable ] Front Glass Panel Slotted Guide Rail and Cable

2 Assembly Frame

3 Inner Seal

• Replacing, refer to => [ Inner Seal ] Inner Seal

4 Bolt

• 2 Nm

5 Rear Frame

• Removing and Installing, refer to => [ Rear Frame ] Rear Frame

6 Rear Motor Support

• Removing and Installing, refer to => [ Rear Motor Support and Sun Shade Cable ] Rear Motor Support and Sun Shade Cable

Removing

- Remove the assembly frame from the vehicle. Refer to => [ Assembly Frame Assembly Overview ] Assembly Frame Assembly Overview.

- Remove the inner seal - 2 - from the assembly frame - 1 -.





- Remove the sun shade. Refer to=> [ Sun Shade ] Sun Shade.

- Loosen the wiring harness from the frame section.

- Remove the screws - 3 - from the frame - 2 - on the guide rail - 1 -.





- Mark the location - arrow - on the frame - 3 - for later assembly.





- Cut the bonded joint - 2 - between the guide rail - 1 - and the frame - 3 - using a knife.

- Pull the whole frame - 1 - and guide tubes - 2 - in - the direction of the arrow - out of the guide rails - 3 -.





Installation

- Remove any adhesive residue with adhesive remover (VAS 6349).

- Clean the adhesive surfaces on the frame and the guide rails using cleaning solution (D 009 401 04).

- Press 3.5 mm butyl adhesive sealing cord (AKD 497 010 04 R10) - 2 - into the adhesive channel on the frame - 1 - as illustrated.





- Slide the entire frame - 2 - and guide tubes - 3 - onto the guide rails - 1 - opposite the - direction of arrow -.





- Tighten the frame - 1 - screws - 3 - on the guide rails - 2 - to 2 Nm.





• Check the assembly frame for leaks before installing.

- Seal the water drain hole - 1 -.





- Fill the area - 3 - between the frame - 2 - and the guide rails - 4 - with water.

- Wait at least 5 minutes and then check for leaks.

- Seal any leaks using the butyl sealing cord (AKD 497 010 04 R10).

- Install the sun shade. Refer to => [ Sun Shade ] Sun Shade.

- Install the sun shade motor. Refer to => [ Roof Blind Control Module ] Roof Blind Control Module.

- Install a new inner seal. Refer to => [ Inner Seal ] Inner Seal.

- Install the assembly frame. Refer to => [ Assembly Frame Assembly Overview ] Assembly Frame Assembly Overview.

- After completing the work procedure, perform an adaptation on all sunroof drives. Refer to => [ Sunroof Adaptation ] Testing and Inspection.