Rear Motor Support and Sun Shade Cable

Rear Motor Support and Sun Shade Cable

Removing

- Remove headliner..

- Remove the sun shade motor. Refer to => [ Roof Blind Control Module ] Roof Blind Control Module.

- Remove the sun shade. Refer to => [ Sun Shade ] Sun Shade.

- Remove the screws - arrows - for the cable covers - 1 - and - 3 -.






- Remove the cable covers - 1 - and - 3 - from the frame - 4 -.

- Remove the sun shade cables from the guide tubes - 3 - and from the motor support - 5 -.

- Pry the motor support - 5 - out of the frame - 1 - with a screwdriver.





- Remove the guide tube - 1 - from the bracket - 4 - in the frame - 2 -.





- Remove the cable - 3 - from the sun shade rail - 5 -.

Installation

To install, perform the steps used in removal in reverse order.

• Do not lubricate the sun shade slide cables and motor support.

- Install the sun shade. Refer to => [ Sun Shade ] Sun Shade.

- Install the sun shade motor. Refer to => [ Roof Blind Control Module ] Roof Blind Control Module.

- Install the headliner..

- After completing the work procedure, perform an adaptation on the sunroof and sun shade motor. Refer to => [ Sunroof Adaptation ] Testing and Inspection.