Floor Console

Floor console

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.




Ignition off

Removing center console





Remove:
- the panel, 4 hidden clips.
Apply the parking brake.





Remove:
- the center console. See: Center console Center Console
- the 2 connectors (1). See: Power socket 12V Power Socket 12V
- the rear center console. See Tunnel console rear Tunnel Console Rear
- the panel under the armrest cover
- the 4 screws
- the parking brake boot by unsnapping it and pulling it over the lever.




Lift the rear edge of the center console and then lift forward/upward.

Remove:
- the connectors beneath the center console.

Transferring center console components

Transfer:
- the cup holder. See: Floor Console Cup holder Floor Console Cup Holder
- armrest cover. See Cover/armrest tunnel compartment Cover/Armrest Tunnel Compartment
- the front storage compartment. See: Storage compartment front center console Storage Compartment Front Center Console.

Installing the center console

Installation:
To install, reverse the removal procedure.