Center Console

Center console

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing center console




Remove the panel inside the center console. It is secured with 4 hidden clips.




Use a small screwdriver and press in the catch in one of the radio panel's upper corners.
Carefully pry off the radio panel on one side using a plastic straightening tool. Perform the same thing on the other side and then fold the radio panel back in the vehicle. Pull the radio panel upwards until it releases.

Hint: If the panel is difficult to remove, press it again on both sides and start again. Start on the opposite side to last time.




Remove the infotainment control module (ICM). It is secured with 2 hidden clips.

Hint: Grip the infotainment control module (ICM) with both hands. Push the control module straight out of the center console.

Remove:
- the 2 connectors from the infotainment control module (ICM)
- the connector from the center console.





Remove:
- the panel. See: Power socket 12V Power Socket 12V
- the 4 screws.
Unclip the gear selector lever boot.
Lift the center console up / out.

Transferring components

Removal of components that are to be transferred.





Remove:
- the 8 screws.
- the rear section of the center console




- the 4 screws
- the climate control module (CCM).

Installation of transferred components

Caution! Tighten the screws carefully. There is a risk of cracks forming.

Install:
- the climate control module (CCM) on the front section of the center console
- the 4 x screws. Tighten. See: Tightening torque [1][2]Body and Frame
- the rear section of the center console
- the 8 screws. Tighten. See: Tightening torque [1][2]Body and Frame.

Installation

Installing the center console

Install:
- the gear selector lever boot
- the center console
- the screws, 4 pcs. Tighten
- the panel. See: Power socket 12V Power Socket 12V
- the connector for the center console
- the 2 connectors for the infotainment control module (ICM)
- the infotainment control module (ICM). It is secured with 2 hidden clips
- the radio panel
- the panel inside the center console. It is secured with 4 hidden clips.