Sealing Flange and Flywheel/Drive Plate Assembly Overview

Sealing Flange and Flywheel/Drive Plate Assembly Overview





1 Belt pulley/vibration damper

• Multiple versions

2 Screws

• 5 pieces

• Replace

• Only use strength category 10.9

• 50 Nm plus an additional 90° (1/4 turn)

3 10 Nm

4 Sealing flange on belt pulley side

• With integrated sealing ring

• Removing and installing => [ Crankshaft Sealing Flange, Belt Pulley Side ] Service and Repair

5 Cylinder block

6 60 Nm plus an additional 90° (1/4 turn)

• Replace

7 Drive plate/flywheel

• To remove, secure crankshaft using locking pin ( T40069).

• Flywheel must not be pried out or timing housing cover will be damaged

• Drive plate, removing and installing => [ Drive Plate ] Drive Plate

8 Sensor wheel

• For Engine Speed (RPM) Sensor (G28)

• With position holder

9 Sealing ring, transmission side

• Removing and installing => [ Seal, Transmission Side ] Seal, Transmission Side

10 Control housing cover

• Removing and installing => [ Control Housing Cover ] Service and Repair

11 O-ring

• Replace

12 25 Nm

13 Fitting sleeves

14 5 Nm

15 Engine speed (RPM) sensor (G28)

16 Seal

• Replace