Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Depth gauge

Removing

- Remove the transmission.

- Lock the crankshaft, refer to => [ Crankshaft, Locking ] Procedures and remove the drive plate.

Installing

- Install the drive plate only using the washer with openings - 1 - and without the shim - 2 -.





- Install new bolts - 3 - and tighten to 30 Nm.

- Check dimension - a - at three points and calculate the average value.





Specified value: 18.8 to 20.4 mm

• Measure through the drive plate hole to the surface of the control housing cover.

If the specification is not obtained:

- Remove the drive plate and install the shim - 2 -. Tighten the bolts - 3 - to 30 Nm again and repeat measurement.





If the specified value is OK:

- Tighten the bolts to 60 Nm + 90° (1/4) additional turn, the additional rotation may occur in several stages).

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the (T40069) from the rear of the cylinder block and install the locking bolt. Tighten the bolt to 45 Nm.