Seal, Transmission Side

Seal, Transmission Side

Special tools, testers and auxiliary items required

• Pulling fixture (T10122)

• Extractor hook (T20143)

Removing

- Remove transmission.

- Secure crankshaft => [ Crankshaft, Locking ] Procedures.

- Remove flywheel or drive plate and remove sensor wheel for Engine Speed (RPM) Sensor (G28) from crankshaft.

- Pull out sealing ring using pulling hook (T20143/2 ).





Do not damage crankshaft sealing surface when doing this.

Installing

• Do not additionally oil or grease sealing lip of oil seal!

- Clean sealing surfaces. They must be free of oil and grease.

- Before installing, remove oil remains from end of crankshaft with a clean cloth.

- Insert assembly device (T10122/1) onto pull sleeve (T10122/2) and slide sealing ring - A - onto pull sleeve.





- Remove assembly device (T10122/1).

- Install pull sleeve (T10122/2) with sealing ring - A - onto crankshaft.





- Press in sealing ring all around evenly and flush using pressure sleeve (T10122/3).

The rest of installation follows the reverse of the removal procedures. When doing this note the following:

• Remove locking pin (T40069) from cylinder block at rear and screw in plug.

Tightening specifications: