Hydraulic System Assembly Overview

Hydraulic System Assembly Overview





1 Brake fluid reservoir

2 Spring-type clamp

3 Supply hose

4 Master cylinder

• Removing and installing --> [ Master Cylinder ] Service and Repair.

5 Clip

• To remove and install hose/line assembly, pull clip out to stop

6 Seal/O-ring

• Always replace

• Install on line connection

• Install with brake fluid

• Seals/O-rings matched to material of line connections --> [ Seals/O-rings for Hose/Line Assemblies ]

7 Base block

• To remove and install, disconnect master cylinder from clutch pedal --> [ Clutch Pedal ] Clutch Pedal.

8 Clutch pedal

• Removing and installing --> [ Clutch Pedal ] Clutch Pedal.

9 Self-locking hex nut, 25 Nm

• Quantity: 3

• Mounting bracket to bulkhead

• Always replace

10 Hose/line assembly

• To remove, remove battery carrier and battery -->.

11 Bracket

• Secured to body

12 Seal/O-ring

• Always replace

• Install on line connection

• Insert with brake fluid

• Seals/O-rings matched to material of line connections --> [ Seals/O-rings for Hose/Line Assemblies ]

13 Bleeder

14 Clip

• To remove and install hose/line assembly or bleeder, pull out clip until stop

15 Bleeder valve

• Clutch system, bleeding --> [ Clutch System Bleeding ] Clutch System Bleeding.

16 Dust cap

17 Slave cylinder

• Can only be replaced when transmission is removed

• Removing and installing --> [ Clutch Release Mechanism Assembly Overview ] Clutch Release Mechanism Assembly Overview.

18 Transmission

Seals/O-rings for Hose/Line Assemblies