Installation (to 12/2010)

2GR-FE CHARGING: GENERATOR: INSTALLATION

1. INSTALL GENERATOR ASSEMBLY

(a) Install the bracket with the bolt.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(b) Install the wire harness clamp stay.

Torque : 8.4 Nm (86 kgf-cm, 74 in-lbf)

(c) Install the generator assembly with the 2 bolts.

Torque : 43 Nm (438 kgf-cm, 32 ft-lbf)

(d) Install the nut to the cylinder block.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(e) Connect the generator connector to the generator assembly.

(f) Install the generator wire with the nut.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(g) Install the terminal cap.

(h) Connect the wire harness clamp.

2. INSTALL V-RIBBED BELT Installation (to 12/2010)

3. INSTALL V-BANK COVER SUB-ASSEMBLY Installation (to 12/2010)

4. CONNECT BATTERY NEGATIVE TERMINAL

5. PERFORM INITIALIZATION

HINT
Repair Instruction - Initialization

(a) Some systems need initialization when disconnecting the battery terminal.