Installation (to 12/2010)

2GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSTALL V-RIBBED BELT

(a) Install the V-ribbed belt.





(b) Using SST, turn the belt tensioner counterclockwise and remove the bi-hexagon wrench.

SST : 09961-00950

(c) If it is difficult to install the V-ribbed belt, perform the following procedure.





(1) Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.

(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulleys.

NOTICE:
* Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
* Check that the V-ribbed belt is properly set to each pulley.

2. INSTALL V-BANK COVER SUB-ASSEMBLY Installation (to 12/2010)

3. INSTALL FRONT FENDER APRON SEAL RH

4. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)