Hydraulic Hose: Service and Repair

CLUTCH PIPING

Removal and Installation











Carefully observe the following steps during clutch tube removal and installation.

CAUTION:
Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash the affected area with water.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

1.Remove the battery, battery tray and brackets. Removal and Replacement.
2.Remove the air cleaner and air duct. Removal And Installation.
3.Use one of the following methods to remove hose from clutch master cylinder.
- Drain clutch fluid from reservoir tank and remove hose.
- Remove hose from clutch master cylinder. Immediately plug hose and reservoir tank to prevent clutch fluid from dripping.

CAUTION:
Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash the affected area with water.
4.Remove clutch tube lock pin from clutch master cylinder.
5.Remove clutch tube lock pin at clutch housing.





6.Remove clutch tube lock pins (2) from clutch damper (3).
7.Remove clutch tube (1) from clutch damper (3).
8.Remove clutch damper (3) from bracket (4).

INSTALLATION

Installation is in the reverse order of removal.
-Make sure that all tubes are fully installed into connectors.
-Make sure that all connector lock pins are fully installed.
- After installation, bleed the air from the clutch hydraulic system. Service and Repair.