Clutch Fluid: Service and Repair

CLUTCH FLUID

Air Bleeding Procedure


CAUTION:
Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash the affected area with water.
NOTE:
Carefully monitor fluid level in reservoir tank during bleeding operation.
1.Fill master cylinder reservoir tank with new clutch fluid.





2.Connect a transparent vinyl tube and container to the bleeding connector (1) on the CSC.
3.Depress and release the clutch pedal slowly and fully 15 times at an interval of two to three seconds and release the clutch pedal.





4.Push in the lock pin (1) of the bleeding connector (2), and maintain the position.

CAUTION:
Hold the lock pin in to prevent the bleeding connector from separating when fluid pressure is applied.





5.Slide bleeding connector (1) in the direction of the arrow as shown to the dimension (A).
2: clutch housing
Dimension (A): 10 mm (0.39 in)
6.Depress the clutch pedal soon and hold it, and then bleed air from the piping. Wait for 5 seconds.

CAUTION:
Hold the clutch pedal down to prevent air from getting back into the clutch system.
7.Return the clutch tube and lock pin to their original positions.
8.Release clutch pedal and wait for 5 seconds.
9.Repeat steps 3 to 8 until no bubbles are observed in the clutch fluid.