Carpet: Service and Repair

FLOOR TRIM


Removal and Installation







REMOVAL
1. Disconnect both the negative and positive battery terminals, then wait at least three minutes.
2. Remove front seat RH/LH and rear seat cushion. Refer to Driver Seat and Component Parts Drawing.
3. Remove floor console and bracket. Refer to Removal And Installation.
4. Remove parking brake control. Refer to Adjustments.
5. Remove center console lower finisher RH/LH and disconnect connector. Refer to Removal And Installation.
6. Remove front kicking plate RH/LH, center pillar lower finisher RH/LH, and both upper and lower rear kicking plates RH/LH. Refer to Body Side Trim.
7. Remove front seat belt lower anchor RH/LH. Refer to Front Seat Belt.
8. Remove diagnosis sensor unit. Refer to Service and Repair.
9. Remove floor carpet hook.
10. Remove instrument panel stay RH/LH. Refer to Removal And Installation.
11. Remove push pin clips, then pull out floor trim through door opening.
12. Remove floor spacer RH/LH/Rear.

INSTALLATION
Installation is in the reverse order of removal.