Installation

SUSPENSION CONTROL: HEIGHT CONTROL COMPRESSOR: INSTALLATION

1. INSTALL HEIGHT CONTROL COMPRESSOR

(a) Install the 3 bushings and bracket to the height control compressor with the 3 bolts.





Torque : 5.9 Nm (60 kgf-cm, 52 in-lbf)

(b) Push the connector into the housing until a clicking sound is heard.

(c) Attach the 3 clamps.

(d) Install the height control sensor with the bolt and 2 nuts.





Torque : 19.1 Nm (195 kgf-cm, 14 ft-lbf)

(e) Connect the height control tube Suspension Control System.

(f) Connect the height control filter to the bumper reinforcement.

(g) Connect the 2 connectors and attach the 2 clamps.





2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

3. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

4. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

5. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.

6. INSPECT FOR AIR LEAK

(a) Inspect for air leak Operation Check.

7. INSTALL FRONT FENDER LINER RH

(a) Install the 2 bolts.

8. INSTALL FRONT BUMPER COVER Installation

9. INSTALL FRONT FENDER LINER LH Installation

10. INSTALL FRONT FENDER LINER RH Installation

11. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH Installation

12. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH Installation

13. INSTALL FRONT FENDER WHEEL OPENING MOULDING LH

14. INSTALL FRONT FENDER WHEEL OPENING MOULDING RH Installation

15. INSTALL RADIATOR GRILLE ASSEMBLY Installation

16. INSTALL COOL AIR INTAKE DUCT SEAL Installation

17. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY Installation

18. INSTALL ENGINE ROOM SIDE COVER LH Installation

19. REMOVE ENGINE ROOM SIDE COVER RH Installation

20. INSTALL FRONT WHEEL RH

Torque : 140 Nm (1428 kgf-cm, 103 ft-lbf)