Installation

SUSPENSION CONTROL: SUSPENSION CONTROL ECU: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Removal.

1. INSTALL SUSPENSION CONTROL ECU

(a) Install the suspension control ECU to the bracket with the 2 nuts.





Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

NOTICE:
* Avoid any impact to the suspension control ECU.
* Do not drop the ECU. If it is dropped, replace it with a new one.

2. INSTALL SUSPENSION CONTROL ECU WITH BRACKET

(a) Install the ECU with bracket with the nut and bolt.





(b) Connect the ECU connectors.





NOTICE:
If the suspension control ECU is replaced with a new one, enter test mode and perform registration of vehicle identification information Programming and Relearning.

3. CONNECT CONNECTORS (w/ Clearance Warning ECU)

4. CONNECT CONNECTORS (w/ Parking Assist ECU)

5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

6. INSTALL NO. 2 INSTRUMENT CLUSTER MOULDING Installation

7. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

8. INSTALL INSTRUMENT PANEL LOWER Installation

9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

10. INSTALL INSTRUMENT SIDE PANEL RH Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

12. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

13. ADJUST VEHICLE HEIGHT

NOTICE:
If the suspension control ECU has been replaced, be sure to adjust the vehicle height.

(a) Adjust the vehicle height Adjustments.

14. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

15. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.

16. ADJUST HEADLIGHT ASSEMBLY

(a) Adjust the headlight Adjustments.