Installation

BRAKE CONTROL: SKID CONTROL BUZZER: INSTALLATION

NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

1. INSTALL SKID CONTROL BUZZER ASSEMBLY

NOTICE:
If the buzzer connector is connected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to install the buzzer according to the procedures below.

(a) Connect the connector.

(b) Attach the clamp and install the buzzer to the extension panel.





2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Installation

3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

4. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Installation

5. INSTALL STEERING COLUMN COVER Installation

6. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING Installation

7. INSTALL INSTRUMENT SIDE PANEL LH Installation

8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSTALL COWL TOP VENTILATOR LOUVER RH Installation