Removal

BRAKE CONTROL: STEERING ANGLE SENSOR: REMOVAL

REMOVAL
NOTE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

1. PRECAUTION
CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing Service Precautions.

2. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
5. REMOVE SWITCH AND VOLUME CASE Removal
6. REMOVE NO. 2 STEERING WHEEL COVER LOWER Removal
7. REMOVE STEERING PAD Removal
8. REMOVE STEERING WHEEL ASSEMBLY Removal
9. REMOVE STEERING COLUMN COVER Removal
10. REMOVE SPIRAL CABLE WITH STEERING SENSOR Removal
11. REMOVE STEERING ANGLE SENSOR