Removal

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. REMOVE SWITCH AND VOLUME CASE Removal
4. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal
5. REMOVE STEERING PAD Removal
6. REMOVE STEERING WHEEL ASSEMBLY Removal
7. REMOVE STEERING COLUMN COVER (W/O Driver Monitor Camera) Removal
8. REMOVE STEERING COLUMN COVER (W/ Driver Monitor Camera) Removal
9. REMOVE SPIRAL CABLE SUB-ASSEMBLY

(a) Disconnect the connectors from the spiral cable with steering angle sensor.
NOTE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Detach the 3 claws and remove the spiral cable with steering angle sensor.