Engine Oil Cooler

Engine Oil Cooler

Special tools, testers and auxiliary items required

• Oil Collection and Extraction Device (V.A.G 1782)

Removing

Vehicles without the After-Run Coolant Pump (V51)

- Drain the coolant. Refer to => [ Coolant, Draining and Filling ] Service and Repair.

Vehicles with the After-Run Coolant Pump (V51)

- Remove the after-run coolant pump. Refer to => [ After-Run Coolant Pump (V51) ] After-Run Coolant Pump (V51).

All Vehicles






- Open the clamp and remove the coolant hose - 1 - and, if necessary, - 2 - from the oil cooler.

- Place the (V.A.G 1782) under the engine.

- Remove the bolts - arrows - and remove the engine oil cooler.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Upper and Lower Oil Pan Sections, Oil Pump and Oil Cooler Overview ] Upper and Lower Oil Pan Sections, Oil Pump and Oil Cooler Overview.

• Replace bolts that are tightened to the specification.

• Replace the gasket.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Parts Catalog.

- Install after-run coolant pump, refer to => [ After-Run Coolant Pump (V51) ] After-Run Coolant Pump (V51).

- Check oil level.

- Fill the coolant => [ Filling ] Service and Repair.