After-Run Coolant Pump (V51)

After-Run Coolant Pump (V51)

Special tools, testers and auxiliary items required

• Drip Tray for VAS 6100 (VAS 6208)

• Hose Clip Pliers (VAS 6340)

Removing

Risk of scalding due to hot steam and hot coolant.

• The coolant system is under pressure when the engine is warm.

• Reduce pressure by covering coolant reservoir cap with a cloth and carefully open.

- Open the coolant reservoir cap.

- Remove the front noise insulation - 1 -..






- Disconnect the connector - 2 -.






- Remove the bolt - 1 -.

- Place the (VAS 6208) under the engine.

- Loosen the clamps - arrows - and remove the coolant hoses from the after-run coolant pump.

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ After-Run Coolant Pump (V51) Overview ] After-Run Coolant Pump (V51) Overview.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Parts Catalog.

- Fill the coolant system. Refer to => [ Filling ] Service and Repair.

- Install the noise insulation..