Exhaust Pressure Regulator Vacuum Solenoid: Service and Repair

Exhaust Flap Control Module

Removing

- Disconnect the connector - 1 -.





- Loosen the clamps - 2 - and - 3 -.

- Remove the exhaust flap control module (J883).

Installing

Installation is in reverse order of removal, note the following:

• Installation position of the seal between the exhaust flap control module (J883) and NOx reservoir or reduction catalytic converter => [ Seal between the and NOx Reservoir or
Reduction Catalytic Converter Installed Position. ] Exhaust Door Control Unit With Reduction Catalytic Converter Assembly Overview.

=> [ Clamps, Installed Position on Exhaust System ] Clamps, Installed Position on Exhaust System

=> [ Exhaust System, Installing ] Exhaust System, Installing