Clamps, Installed Position on Exhaust System

Clamps, Installed Position on Exhaust System

Clamp Installation Position between the Particulate Filter and Turbocharger





- Install the clamp so that the clamping screw faces downward while maintaining a - ± 10° - angle.

Clamp Installation Position between the Particulate Filter and Exhaust Gas Recirculation Filter





- Install the clamp so that the clamping bolt faces downward while maintaining a - ± 10° - angle.

- Install the exhaust gas temperature sensor maintaining the angle:

1. Exhaust gas temperature 3 (G495): angle - 23° -

2. Exhaust gas temperature 2 (G448): angle - 30° -

Clamps between the Particulate Filter and the NOx Reduction Catalytic Converter, the Exhaust Flap Control Module (J883) and the NOx Reservoir or Reduction Catalytic Converter Installed Locations





- Install the clamp so that the - 45° ± 10° - is maintained.

Clamping Sleeve Location





- Install clamping sleeve so that bolt end does not project beyond lower edge of clamping sleeve - arrow -.

• Threaded connection points toward the right.